close
close

How To Light A Gas Fireplace With A Wall Switch

How To Light A Gas Fireplace With A Wall Switch

How To Light A Gas Fireplace With A Wall Switch. Insert the key into the gas valve. Once the burner is lit, replace the key cover.

How To Light A Gas Fireplace With A Wall SwitchHow To Light A Gas Fireplace With A Wall Switch
My gas fireplace pilot light works perfectly. However, when I flip the from www.quora.com

Make sure the pilot light is on by looking at the control panel on the front of the fireplace. Turn gas control unit the pilot setting aligns with the. How to light a gas fireplace.

Remove The Access Cover To The Controls.

This will then allow the gas to start flowing into the system. Written by chad peterson in need to know. To ignite the pilot light, press your finger into the center of the control knob and hold it in place.

READ this  Shooting Games Unblocked 66

If You Dont See Any Button, You Must Light The Flame Manually.

You may hear a slight hissing as the gas enters the burner, and the pilot light should light. Not all of the fireplaces have a wall switch that can turn on as. If it isn’t lit, turn the knob.

Check For A Loose Wire Connection On The Terminals.

If you first move into a home with a gas fireplace, you may not know how to even turn it on. To adjust the flame with an adjustment knob, just follow these steps: It looks like a small wheel.

How To Light A Gas Fireplace.

Do not turn the key until you are ready to light the burner. Make sure the pilot light is on by looking at the control panel on the front of the fireplace. Operation is very easy as all you need to do is push a switch to turn on or off.

Press The Button To Verify That Theres A Spark At The End Of The Pilot Tube.

It's probably just a matter of finding a switch with a low enough on. The fireplace should light immediately. Gas fireplace wall switch not working 3 fixes how to air.

You may also like...

Leave a Reply

Your email address will not be published. Required fields are marked *